Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Ardo AL02
FAQ TREEWhat does error code AL02 mean on a Ardo appliance?
Ardo error code AL02 indicates: Ardo DWA / DW60 Electronic Integrated & Freestanding Dishwasher: Diagnostic fault code AL02 registered by the microcomputer controller. Water intake filling timeout; flow meter impeller pulses not detected by microcomputer.
What is the root cause of Ardo error code AL02?
The primary root cause for Ardo code AL02 is: On Ardo appliances engineered with tachometric circulation wash pump, 2040W flow-through heater, Bitron overflow float microswitch, and 10 kΩ NTC turbidity sensor: flow meter reed switch contact defective or water inlet solenoid valve screen mesh blocked Metrological tolerance verification: flow meter calibration ~120 pulses per liter; valve coil resistance 3.8 kΩ to 4.4 kΩ..
How do I fix or resolve Ardo error code AL02?
To resolve error code AL02: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure valve coil resistance and test reed switch output pulses (0V to 5V DC) during water fill. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Switch on power. Press and hold the Program Selection key for 5 seconds until the cycle progress LEDs flash simultaneously and the acoustic tone beeps three times. Turn off machine at master power button, wait 15 seconds, and restart standard cycle.
Is it safe to clear Ardo error code AL02 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Ardo code AL02 persists, the physical component causing On Ardo appliances engineered with tachometric circulation wash pump, 2040W flow-through heater, Bitron overflow float microswitch, and 10 kΩ NTC turbidity sensor: flow meter reed switch contact defective or water inlet solenoid valve screen mesh blocked Metrological tolerance verification: flow meter calibration ~120 pulses per liter; valve coil resistance 3.8 kΩ to 4.4 kΩ. must be inspected or replaced.
How do I test electrical resistance for Ardo code AL02 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Ardo code AL02?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?