Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bauknecht F26
FAQ TREEWhat does error code F26 mean on a Bauknecht appliance?
Bauknecht error code F26 indicates: Bauknecht SuperEco & GentlePower Zen Motor Direct Drive Washing Machine: Main drain pump triac driver fault F26; power board detects shorted or open triac output stage to pump motor..
What is the root cause of Bauknecht error code F26?
The primary root cause for Bauknecht code F26 is: On Bauknecht washing machines: Water ingress into drain pump motor body causing winding short circuit that punctures the board triac driver..
How do I fix or resolve Bauknecht error code F26?
To resolve error code F26: Inspect drain pump for signs of water leaking down shaft into coil. Measure pump resistance (160–185 Ω). Replace pump and repair or replace power module. Turn selector to Drain/Spin, press Start/Pause button 4 times within 5 seconds to clear fault, or hold Reset for 3s.
Is it safe to clear Bauknecht error code F26 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bauknecht code F26 persists, the physical component causing On Bauknecht washing machines: Water ingress into drain pump motor body causing winding short circuit that punctures the board triac driver. must be inspected or replaced.
How do I test electrical resistance for Bauknecht code F26 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Bauknecht code F26?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



