Bompani r01

Bompani error code R01 indicates: Bompani Retrò 50s Style & Contemporary Total NoFrost Dual-Cooling Refrigerator: Operational diagnostic fault code r01 signaled by internal electronics. Fresh food refrigerator compartment temperature sensor NTC open or short circuit (<800 Ω or >200 kΩ).

The primary root cause for Bompani code R01 is: On Bompani kitchen suites engineered with Total NoFrost air tower, 240W defrost heating element (220-320 Ω), 72°C bimetal thermal fuse, 10 kΩ NTC evaporator thermistors, and motorized damper: Thermistor wire pinched in cabinet liner, sensor capsule moisture ingress, or connector oxidation Multimeter diagnostic parameter: nominal NTC resistance 10.0 kΩ at 25°C, 27.5 kΩ at 4°C, 32.5 kΩ at 0°C; smooth continuous curve..

To resolve error code R01: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: unplug sensor connector from main PCB and measure resistance across pins at known air temperature. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Open refrigerator door. Press and hold Fast Cool and Temperature Set buttons together for 6 seconds until display chimes and shows '00', clearing logged faults.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code R01 persists, the physical component causing On Bompani kitchen suites engineered with Total NoFrost air tower, 240W defrost heating element (220-320 Ω), 72°C bimetal thermal fuse, 10 kΩ NTC evaporator thermistors, and motorized damper: Thermistor wire pinched in cabinet liner, sensor capsule moisture ingress, or connector oxidation Multimeter diagnostic parameter: nominal NTC resistance 10.0 kΩ at 25°C, 27.5 kΩ at 4°C, 32.5 kΩ at 0°C; smooth continuous curve. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.