Bompani r06

Bompani error code R06 indicates: Bompani Retrò 50s Style & Contemporary Total NoFrost Dual-Cooling Refrigerator: Operational diagnostic fault code r06 signaled by internal electronics. Evaporator forced-air circulation fan motor winding open circuit or rotor mechanically seized.

The primary root cause for Bompani code R06 is: On Bompani kitchen suites engineered with Total NoFrost air tower, 240W defrost heating element (220-320 Ω), 72°C bimetal thermal fuse, 10 kΩ NTC evaporator thermistors, and motorized damper: Heavy frost accumulation blocking fan blades, seized motor sleeve bearing, or electronic driver failure Multimeter diagnostic parameter: 12V DC brushless evaporator fan draws nominal 150-250 mA; internal winding resistance 35 Ω to 65 Ω..

To resolve error code R06: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: inspect fan blade clearance from frost buildup, spin rotor freely by hand, and measure 12V DC supply voltage. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Open refrigerator door. Press and hold Fast Cool and Temperature Set buttons together for 6 seconds until display chimes and shows '00', clearing logged faults.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code R06 persists, the physical component causing On Bompani kitchen suites engineered with Total NoFrost air tower, 240W defrost heating element (220-320 Ω), 72°C bimetal thermal fuse, 10 kΩ NTC evaporator thermistors, and motorized damper: Heavy frost accumulation blocking fan blades, seized motor sleeve bearing, or electronic driver failure Multimeter diagnostic parameter: 12V DC brushless evaporator fan draws nominal 150-250 mA; internal winding resistance 35 Ω to 65 Ω. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.