Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bosch F3
FAQ TREEWhat does error code F3 mean on a Bosch appliance?
Bosch error code F3 indicates: Bosch Serie 6 / Serie 8 FlexInduction & PerfectFry Induction Cooktop: Electronic heat sink over-temperature F3; power module aluminum heatsink thermistor exceeds 85°C limit..
What is the root cause of Bosch error code F3?
The primary root cause for Bosch code F3 is: On Bosch hobs: Blocked cooling air intake underneath cooktop, cooling fan failure, or degraded thermal pad on IGBT heat sink..
How do I fix or resolve Bosch error code F3?
To resolve error code F3: Check under-counter ventilation space. Test cooling fan operation in service mode. Measure heatsink NTC resistance (~10 kΩ at 25°C). Turn off all cooking zones, switch off mains circuit breaker for 30 seconds, restore power, hold Key lock for 4 seconds.
Is it safe to clear Bosch error code F3 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bosch code F3 persists, the physical component causing On Bosch hobs: Blocked cooling air intake underneath cooktop, cooling fan failure, or degraded thermal pad on IGBT heat sink. must be inspected or replaced.
How do I test electrical resistance for Bosch code F3 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Bosch code F3?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



