Brandt d16

Brandt error code D16 indicates: Brandt Malice / Condensation & Heat Pump Tumble Dryer: Door latch open during cycle d16; cycle pauses immediately as door contact microswitch opens during active operation..

The primary root cause for Brandt code D16 is: On Brandt tumble dryers utilizing Malice top-loading thermodynamic drying circuit, electronic condenser monitoring, and bi-directional drum tumbling: Worn door catch pin, loose latch microswitch mounting bracket, or broken door strike tongue..

To resolve error code D16: Inspect door catch alignment and latch engagement. Test door microswitch continuity (~0 Ω closed, infinite open) with a multimeter. Turn cycle selector to Stop, press and hold Start and Delay Start together for 5 seconds until a double beep sounds, then return to Off.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Brandt code D16 persists, the physical component causing On Brandt tumble dryers utilizing Malice top-loading thermodynamic drying circuit, electronic condenser monitoring, and bi-directional drum tumbling: Worn door catch pin, loose latch microswitch mounting bracket, or broken door strike tongue. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test PTC Heater Pellet / Pulse Solenoid / Microswitch Contacts across Across PTC heater terminals on lock bezel; switch contact reads <0.2Ω when locked. Expected nominal reading is 800Ω–1.5kΩ (PTC terminals L-N) / 60Ω–120Ω (Pulse Solenoid). Tolerance: ±15%. Switch contacts must read open (OL) when unlocked and 0.0Ω–0.2Ω when fully latched..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.