Candy F1 — Dryer
[ACTIVE]Candy RapidÓ / Smart Pro Heat-Pump & Condenser Dryer: Air intake temperature sensor fault F1; front air temperature probe disconnected or reading outside allowable bounds.
On Candy dryers utilizing RapidÓ heat-pump thermodynamic circuit, 7-sensor electronic moisture tracking, and hOn remote diagnostics: Defective front NTC thermistor, loose pin terminal on air duct harness, or internal short circuit.
Disconnect wire harness at front sensor. Measure resistance (~10 kΩ–20 kΩ at 25°C). Replace sensor assembly if open or short. Switch selector to Off, press and hold Start and Delay Start together for 5 seconds until buzzer beeps twice, then turn to 12 o'clock.



