Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Daewoo IE
FAQ TREEWhat does error code IE mean on a Daewoo appliance?
Daewoo error code IE indicates: Daewoo DDW Series Ultra Clean AquaStop Dishwasher: Diagnostic fault code IE registered by the microcomputer controller. Water inlet failure (no water inflow detected by flowmeter within 2 minutes of valve actuation).
What is the root cause of Daewoo error code IE?
The primary root cause for Daewoo code IE is: On Daewoo appliances engineered with hydraulic high-pressure wash pump, triple fine-mesh sump filter, electronic overflow float switch, and inline flow-through heating element: Home water supply tap closed, AquaStop safety hose tripped mechanically, broken inlet valve coil, or mesh clogged Metrological tolerance verification: AquaStop inlet valve solenoid coil resistance 3.5 kΩ to 4.2 kΩ at 20°C..
How do I fix or resolve Daewoo error code IE?
To resolve error code IE: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: verify water pressure at tap (>1.5 bar); measure AquaStop valve coil resistance (3.5-4.2 kΩ); clean inlet screen filter. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Switch machine off. Press and hold Program and Delay buttons together while pressing Power On. Hold for 4 seconds until status LEDs flash rapidly. Press and hold Start/Pause for 3 seconds until the drain pump activates for a 30-second cycle to purge water and clear error lock.
Is it safe to clear Daewoo error code IE by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Daewoo code IE persists, the physical component causing On Daewoo appliances engineered with hydraulic high-pressure wash pump, triple fine-mesh sump filter, electronic overflow float switch, and inline flow-through heating element: Home water supply tap closed, AquaStop safety hose tripped mechanically, broken inlet valve coil, or mesh clogged Metrological tolerance verification: AquaStop inlet valve solenoid coil resistance 3.5 kΩ to 4.2 kΩ at 20°C. must be inspected or replaced.
How do I test electrical resistance for Daewoo code IE using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Daewoo code IE?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?