Daewoo r6

Daewoo error code R6 indicates: Daewoo Nano-Silver / Total NoFrost Side-by-Side & Combi Refrigerator: Diagnostic fault code r6 registered by the microcomputer controller. Wine cellar / beverage center compartment temperature sensor circuit open or out of calibration limits.

The primary root cause for Daewoo code R6 is: On Daewoo appliances engineered with Nano-Silver antibacterial coating, Multi-Air Flow dynamic ventilation ducting, motorized air baffle damper, electronic defrost heater sheath, and precision 2.0 kΩ/10 kΩ NTC thermistors: Beverage zone NTC thermistor element fractured, plug pins oxidized by condensate runoff, or pinched wire harness Metrological tolerance verification: wine / beverage compartment NTC resistance nominal 2.0 kΩ at 25°C (3.5 kΩ to 3.8 kΩ at 12°C cellar temperature)..

To resolve error code R6: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: unplug sensor connector in beverage cavity and measure resistance (spec: 3.5-3.8 kΩ at 12°C); replace probe if open circuit. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Open fresh food door. Press and hold 'Refrigerator Temp' and 'Super Freeze' (or 'Ice Maker Off') buttons on the control panel simultaneously for 5 seconds until an acoustic chime sounds. Hold 'Alarm Reset' (or 'Freezer Temp') for 3 seconds until the display chimes twice and returns to normal temperature settings, clearing stored error history.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Daewoo code R6 persists, the physical component causing On Daewoo appliances engineered with Nano-Silver antibacterial coating, Multi-Air Flow dynamic ventilation ducting, motorized air baffle damper, electronic defrost heater sheath, and precision 2.0 kΩ/10 kΩ NTC thermistors: Beverage zone NTC thermistor element fractured, plug pins oxidized by condensate runoff, or pinched wire harness Metrological tolerance verification: wine / beverage compartment NTC resistance nominal 2.0 kΩ at 25°C (3.5 kΩ to 3.8 kΩ at 12°C cellar temperature). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.