Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: De Dietrich AL02
FAQ TREEWhat does error code AL02 mean on a De Dietrich appliance?
De Dietrich error code AL02 indicates: De Dietrich Prestige No Frost / DRS Multi-Zone Refrigerator: Door open warning signal persistent AL02; acoustic door alarm sounds and interior light remains energized with door shut..
What is the root cause of De Dietrich error code AL02?
The primary root cause for De Dietrich code AL02 is: On De Dietrich refrigeration units featuring Prestige No Frost multi-sensor refrigeration, active preservation zone, and inverter compressor modulation: Displaced door magnet, stuck mechanical pushbutton switch, or failed reed sensor switch inside the control panel frame..
How do I fix or resolve De Dietrich error code AL02?
To resolve error code AL02: Test door switch continuity with a multimeter: must toggle from 0 Ω (closed door) to infinite Ω (open door). Check that door magnet in upper door edge is properly seated. Touch and hold the Alarm Acknowledge and Quick Chill icons for 8 seconds until the ICS chime signals buffer reset, then release.
Is it safe to clear De Dietrich error code AL02 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if De Dietrich code AL02 persists, the physical component causing On De Dietrich refrigeration units featuring Prestige No Frost multi-sensor refrigeration, active preservation zone, and inverter compressor modulation: Displaced door magnet, stuck mechanical pushbutton switch, or failed reed sensor switch inside the control panel frame. must be inspected or replaced.
How do I test electrical resistance for De Dietrich code AL02 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing De Dietrich code AL02?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



