Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Electroline F16
FAQ TREEWhat does error code F16 mean on a Electroline appliance?
Electroline error code F16 indicates: Electroline EDW / AquaStop Electronic Built-in Dishwasher: Diagnostic fault code F16 registered by the microcomputer controller. Detergent door flap release wax motor or solenoid actuator circuit open.
What is the root cause of Electroline error code F16?
The primary root cause for Electroline code F16 is: System architecture (Electroline wash architecture, synchronous wash circulation pump, 1900W flow heater, and turbidity sensor): internal PTC wax heater pellet burned out or door flap mechanical spring latch broken. Metrological test specification: wax motor actuator resistance 1.2 kΩ to 2.4 kΩ at 20°C; 230V AC drive pulse duration 60s..
How do I fix or resolve Electroline error code F16?
To resolve error code F16: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: open inner door skin; measure resistance across dispenser actuator terminals with multimeter. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: press and hold the Start/Cancel button for 4 seconds until the active program LED turns off and the drain pump clears the sump for 25 seconds.
Is it safe to clear Electroline error code F16 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Electroline code F16 persists, the physical component causing System architecture (Electroline wash architecture, synchronous wash circulation pump, 1900W flow heater, and turbidity sensor): internal PTC wax heater pellet burned out or door flap mechanical spring latch broken. Metrological test specification: wax motor actuator resistance 1.2 kΩ to 2.4 kΩ at 20°C; 230V AC drive pulse duration 60s. must be inspected or replaced.
How do I test electrical resistance for Electroline code F16 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Electroline code F16?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?