Electroline F10

Electroline error code F10 indicates: Electroline EDW / AquaStop Electronic Built-in Dishwasher: Diagnostic fault code F10 registered by the microcomputer controller. AquaStop anti-flood safety switch in bottom drip tray activated by standing water leak.

The primary root cause for Electroline code F10 is: System architecture (Electroline wash architecture, synchronous wash circulation pump, 1900W flow heater, and turbidity sensor): door perimeter gasket leaking, spray arm split along seam, or sump seal O-ring degraded. Metrological test specification: float switch resistance < 0.2 Ω when lowered dry; open circuit when buoyant styrofoam lifts..

To resolve error code F10: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: unplug dishwasher; sop up standing water in base tray and inspect wash arms and hoses for leaks. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: press and hold the Start/Cancel button for 4 seconds until the active program LED turns off and the drain pump clears the sump for 25 seconds.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Electroline code F10 persists, the physical component causing System architecture (Electroline wash architecture, synchronous wash circulation pump, 1900W flow heater, and turbidity sensor): door perimeter gasket leaking, spray arm split along seam, or sump seal O-ring degraded. Metrological test specification: float switch resistance < 0.2 Ω when lowered dry; open circuit when buoyant styrofoam lifts. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.