Electrolux EF3

Electrolux error code EF3 indicates: Electrolux PerfectCare 600/700/800 UltraCare Washer: AquaControl anti-flood protection active EF3; float switch triggered in base pan with continuous safety drain..

The primary root cause for Electrolux code EF3 is: On Electrolux (Electrolux PerfectCare 600/700/800 UltraCare Washer) models: Water leak from tub hose, split door bellow gasket, leaking water inlet valve, or drain pump housing crack accumulating water in base..

To resolve error code EF3: Disconnect power and shut water tap. Tilt machine backward 45° to drain base tray onto towels. Locate leak source and replace leaking component. Hold Start/Pause and Delay Start together for 5 seconds on program position 10 until the acoustic chime sounds and display resets to 0:00.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Electrolux code EF3 persists, the physical component causing On Electrolux (Electrolux PerfectCare 600/700/800 UltraCare Washer) models: Water leak from tub hose, split door bellow gasket, leaking water inlet valve, or drain pump housing crack accumulating water in base. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.