Faber H

Faber error code H indicates: Alarm sounds and 'H' flashes on display.

The primary root cause for Faber code H is: High temperature alarm. The internal temperature of a compartment is too warm. This can be caused by a door left ajar, a recent large grocery load, or a cooling system failure..

To resolve error code H: Ensure the door is fully closed and gaskets are sealing properly. Allow several hours for the temperature to stabilize. If the alarm persists, seek professional service.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Faber code H persists, the physical component causing High temperature alarm. The internal temperature of a compartment is too warm. This can be caused by a door left ajar, a recent large grocery load, or a cooling system failure. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.