FAGOR d18

FAGOR error code D18 indicates: Fagor Innova / SFS Condensation & Heat Pump Tumble Dryer: Maximum drying cycle timeout exceeded d18; machine aborts after running for over 180 minutes without reaching target dry state..

The primary root cause for FAGOR code D18 is: On FAGOR tumble dryers utilizing Innova thermodynamic refrigeration circuit, dual conductivity sensor bars, and reversible drum rotation: Wet overloaded laundry from an unspun washer cycle (<800 RPM), severely blocked condenser, or weak heat pump performance..

To resolve error code D18: Spin clothes in washing machine at 1200+ RPM prior to drying. Wash condenser core thoroughly. Reduce total laundry weight in drum. Turn dial to Off position, hold Start and Anti-Crease buttons together for 6 seconds until buzzer beeps, then turn back on.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if FAGOR code D18 persists, the physical component causing On FAGOR tumble dryers utilizing Innova thermodynamic refrigeration circuit, dual conductivity sensor bars, and reversible drum rotation: Wet overloaded laundry from an unspun washer cycle (<800 RPM), severely blocked condenser, or weak heat pump performance. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Protective Earth Bonding & Incoming Mains Voltage across Between unpainted chassis metal and mains plug earth pin; incoming terminal block L-N. Expected nominal reading is Earth Ground Continuity: <0.1Ω (Chassis metal to mains plug earth pin). Mains: 230V AC ±10%.. Tolerance: Protective conductor impedance must remain <0.1Ω. Line voltage 207V–253V AC under load..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.