FAGOR E2

FAGOR error code E2 indicates: Fagor Innova Induction / IF / 2IF / 3IF High-Power Cooktop: Induction coil temperature sensor fault E2; zone display flashes 'E2' and cuts power to prevent glass overheating..

The primary root cause for FAGOR code E2 is: On FAGOR cooktops utilizing Innova high-frequency induction generator, ferromagnetic pan detection resonance, and rapid booster stages: Open or shorted spring-loaded center coil NTC thermistor (~100 kΩ at 25°C), or detached silicone thermal boot..

To resolve error code E2: Access coil assembly beneath glass. Measure coil center NTC sensor resistance (~100 kΩ at 25°C, dropping to ~10 kΩ at 80°C). Replace sensor if open. Clear and dry cooktop surface, disconnect mains power breaker for 60 seconds, reconnect and hold Key Padlock sensor for 5 seconds.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if FAGOR code E2 persists, the physical component causing On FAGOR cooktops utilizing Innova high-frequency induction generator, ferromagnetic pan detection resonance, and rapid booster stages: Open or shorted spring-loaded center coil NTC thermistor (~100 kΩ at 25°C), or detached silicone thermal boot. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.