FAGOR Er14

FAGOR error code ER14 indicates: Fagor Masterchef / Innova / 6H Pyrolytic Multi-Function Oven: Capacitive touch panel continuous keypress error Er14; touch control button registers continuous contact for longer than 10 seconds..

The primary root cause for FAGOR code ER14 is: On FAGOR built-in ovens featuring Masterchef 6H pyrolytic thermal management, high-flow tangential cooling turbine, and digital programmer interface: Greasy residue, condensation film over glass front, or detached conductive foam spacer under glass..

To resolve error code ER14: Clean front glass panel with a microfiber cloth and glass cleaner. Ensure hands are dry. Power cycle circuit breaker for 60 seconds to recalibrate capacitance. Return function selector to 0, isolate the power distribution breaker for 60 seconds, restore power and configure the clock.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if FAGOR code ER14 persists, the physical component causing On FAGOR built-in ovens featuring Masterchef 6H pyrolytic thermal management, high-flow tangential cooling turbine, and digital programmer interface: Greasy residue, condensation film over glass front, or detached conductive foam spacer under glass. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test PCB Power Supply Rails & DC Bus Filter Capacitors across Across SMPS output electrolytic capacitors on low-voltage side (test bench verification). Expected nominal reading is Low-voltage rails: +5.0V DC (Logic), +12.0V DC (Relays), +3.3V DC (MCU). Relay coils: 200Ω–450Ω.. Tolerance: DC rail ripple must remain <50mV. Direct continuity (0Ω) across DC bus rails indicates dead short..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.