Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Favorit E11
FAQ TREEWhat does error code E11 mean on a Favorit appliance?
Favorit error code E11 indicates: Favorit ProCare / SwissWash High-Efficiency Electronic Washing Machine: Diagnostic fault code E11 registered by the microcomputer controller. Washing machine wash water fill timeout; dynamic water level not reached within 5 minutes (code E11).
What is the root cause of Favorit error code E11?
The primary root cause for Favorit code E11 is: On Favorit SwissLine and European precision appliances built for high durability engineered with Eco-Inverter BLDC direct drive motor (5.5-8.0 Ω per phase), 2100W heating element (24-27 Ω), 10 kΩ NTC thermistor at 25°C, pneumatic pressure switch with sealed air trap, and instant bi-metal door lock: closed supply tap, kinked inlet hose, clogged wire mesh filter screen, or wash solenoid coil open circuit. Metrological tolerance verification: wash inlet solenoid valve coil resistance 3.5 kΩ to 4.5 kΩ at 20°C; incoming water flow rate >8.0 L/min..
How do I fix or resolve Favorit error code E11?
To resolve error code E11: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: verify water tap is fully open, clean debris from inlet hose filter mesh, and test solenoid coil resistance (~4.0 kΩ). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn cycle selector to Stop. Hold Start/Pause and Eco buttons together for 5 seconds until display chimes and shows 'CLr', wiping diagnostic fault memory.
Is it safe to clear Favorit error code E11 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code E11 persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with Eco-Inverter BLDC direct drive motor (5.5-8.0 Ω per phase), 2100W heating element (24-27 Ω), 10 kΩ NTC thermistor at 25°C, pneumatic pressure switch with sealed air trap, and instant bi-metal door lock: closed supply tap, kinked inlet hose, clogged wire mesh filter screen, or wash solenoid coil open circuit. Metrological tolerance verification: wash inlet solenoid valve coil resistance 3.5 kΩ to 4.5 kΩ at 20°C; incoming water flow rate >8.0 L/min. must be inspected or replaced.
How do I test electrical resistance for Favorit code E11 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Favorit code E11?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



