Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Favorit E41
FAQ TREEWhat does error code E41 mean on a Favorit appliance?
Favorit error code E41 indicates: Favorit ProCare / SwissWash High-Efficiency Electronic Washing Machine: Diagnostic fault code E41 registered by the microcomputer controller. Washing machine door open or unlatched; cycle start aborted because door contact failed to make (code E41).
What is the root cause of Favorit error code E41?
The primary root cause for Favorit code E41 is: On Favorit SwissLine and European precision appliances built for high durability engineered with Eco-Inverter BLDC direct drive motor (5.5-8.0 Ω per phase), 2100W heating element (24-27 Ω), 10 kΩ NTC thermistor at 25°C, pneumatic pressure switch with sealed air trap, and instant bi-metal door lock: door not closed firmly, striker hook misaligned with lock bezel, or internal microswitch contacts corroded. Metrological tolerance verification: door microswitch closed contact resistance must be <0.5 Ω with door latched; open circuit when ajar..
How do I fix or resolve Favorit error code E41?
To resolve error code E41: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: push door firmly to latch hook, verify door hinge has no sag, and test continuity across door lock switch pins. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn cycle selector to Stop. Hold Start/Pause and Eco buttons together for 5 seconds until display chimes and shows 'CLr', wiping diagnostic fault memory.
Is it safe to clear Favorit error code E41 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code E41 persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with Eco-Inverter BLDC direct drive motor (5.5-8.0 Ω per phase), 2100W heating element (24-27 Ω), 10 kΩ NTC thermistor at 25°C, pneumatic pressure switch with sealed air trap, and instant bi-metal door lock: door not closed firmly, striker hook misaligned with lock bezel, or internal microswitch contacts corroded. Metrological tolerance verification: door microswitch closed contact resistance must be <0.5 Ω with door latched; open circuit when ajar. must be inspected or replaced.
How do I test electrical resistance for Favorit code E41 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Favorit code E41?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



