Favorit F08_RF

Favorit error code F08_RF indicates: Favorit BioFresh / SwissCool Total NoFrost Inverter Refrigerator: Diagnostic fault code F08_RF registered by the microcomputer controller. Refrigerator evaporator glass-tube defrost heating element open circuit (240W, nominal 210-280 Ω) (code F08).

The primary root cause for Favorit code F08_RF is: On Favorit SwissLine and European precision appliances built for high durability engineered with variable-speed inverter compressor (8-12 Ω three-phase), 240W defrost heating glass-tube element (210-280 Ω), 5 kΩ NTC compartment sensors at 25°C, and motorized air distribution damper: thermal shock cracked internal tungsten-alloy wire coil inside glass sheath or terminal lug burned. Metrological tolerance verification: nominal defrost heater resistance 210 Ω to 280 Ω at 20°C (240W); infinite resistance indicates element break..

To resolve error code F08_RF: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: disconnect defrost heater terminals behind evaporator panel and measure element resistance with digital ohmmeter. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold Alarm Off and Fridge Temp buttons simultaneously for 5 seconds until digital display flashes '00' and resets cooling microprocessor.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code F08_RF persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with variable-speed inverter compressor (8-12 Ω three-phase), 240W defrost heating glass-tube element (210-280 Ω), 5 kΩ NTC compartment sensors at 25°C, and motorized air distribution damper: thermal shock cracked internal tungsten-alloy wire coil inside glass sheath or terminal lug burned. Metrological tolerance verification: nominal defrost heater resistance 210 Ω to 280 Ω at 20°C (240W); infinite resistance indicates element break. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.