Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Gea-Appliances HP18
FAQ TREEWhat does error code HP18 mean on a GEA Appliances appliance?
GEA Appliances error code HP18 indicates: GEA Bock / Grasso / Matrix European High-Efficiency Chiller, Heat Pump & Air Handling System: Diagnostic fault code HP18 registered by the microcomputer controller. Heat pump automated reverse defrost cycle exceeds maximum duration threshold of 15 minutes.
What is the root cause of GEA Appliances error code HP18?
The primary root cause for GEA Appliances code HP18 is: System architecture (GEA industrial microprocessor PLC, 4-20mA pressure transmitters, electronic expansion valve EEV, and PT1000 temperature probes): refrigerant undercharge, outdoor coil temperature probe unclipped, or 4-way reversing valve stuck. Metrological test specification: defrost termination PT1000 sensor resistance 1039 Ω at 10.0°C; 4-way valve coil 1.8 kΩ to 2.4 kΩ..
How do I fix or resolve GEA Appliances error code HP18?
To resolve error code HP18: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: inspect 4-way valve pilot tubes for temperature shift; measure PT1000 defrost probe resistance. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: access controller interface, navigate to Alarm Log menu, hold Alarm Reset key for 5 seconds until the warning banner turns green and safety relay re-engages.
Is it safe to clear GEA Appliances error code HP18 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if GEA Appliances code HP18 persists, the physical component causing System architecture (GEA industrial microprocessor PLC, 4-20mA pressure transmitters, electronic expansion valve EEV, and PT1000 temperature probes): refrigerant undercharge, outdoor coil temperature probe unclipped, or 4-way reversing valve stuck. Metrological test specification: defrost termination PT1000 sensor resistance 1039 Ω at 10.0°C; 4-way valve coil 1.8 kΩ to 2.4 kΩ. must be inspected or replaced.
How do I test electrical resistance for GEA Appliances code HP18 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing GEA Appliances code HP18?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



