Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Gree / Mace PL
FAQ TREEWhat does error code PL mean on a Gree-Mace appliance?
Gree-Mace error code PL indicates: Gree-Mace G10 Inverter / Free Match / GMV5 / GMV6 Multi-VRF Commercial & Residential HVAC: Diagnostic fault code PL registered by the microcomputer controller. DC bus intermediate voltage dropping below operational minimum threshold (< 200V).
What is the root cause of Gree-Mace error code PL?
The primary root cause for Gree-Mace code PL is: On Gree-Mace appliances engineered with Gree G10 Inverter low-frequency torque control, intelligent dual-stage rotary compressor, 46 Ω electronic expansion valve stepping motor coils, high-voltage PFC boost circuit (380V DC), and precision NTC thermistors (15 kΩ ambient, 20 kΩ coil, 50 kΩ discharge): inverter DC bus intermediate circuit voltage dropping below 200V DC under load Metrological tolerance verification: DC bus low limit trip threshold < 200V DC; nominal 310V to 380V DC..
How do I fix or resolve Gree-Mace error code PL?
To resolve error code PL: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: verify incoming AC mains voltage under full load and test bridge rectifier diode drops. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Using the remote controller: point at the unit and press 'LIGHT' 6 times in 3 seconds (or hold 'TURBO' + 'MODE' for 5 seconds) to enter diagnostic query mode. For inverter lockout errors (H5, HC, P0, P8, E6), switch off the external electrical isolator / circuit breaker for at least 3 minutes to allow DC bus capacitors to fully discharge.
Is it safe to clear Gree-Mace error code PL by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Gree-Mace code PL persists, the physical component causing On Gree-Mace appliances engineered with Gree G10 Inverter low-frequency torque control, intelligent dual-stage rotary compressor, 46 Ω electronic expansion valve stepping motor coils, high-voltage PFC boost circuit (380V DC), and precision NTC thermistors (15 kΩ ambient, 20 kΩ coil, 50 kΩ discharge): inverter DC bus intermediate circuit voltage dropping below 200V DC under load Metrological tolerance verification: DC bus low limit trip threshold < 200V DC; nominal 310V to 380V DC. must be inspected or replaced.
How do I test electrical resistance for Gree-Mace code PL using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Gree-Mace code PL?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



