Hoover E21 — Dryer
[ACTIVE]Hoover H-DRY 300 / 500 Heat-Pump & Auto Care Tumble Dryer: Moisture sensing calibration amplifier fault E21; analog-to-digital converter receives out-of-scale conductance baseline.
On Hoover tumble dryers utilizing H-DRY Auto Care thermodynamic heat-pump circuit, active conductivity sensor bars, and Eco-Power compressor control: Wet conductive fluff bridging sensor strips to chassis, moisture inside front fascia harness, or operational amplifier IC drift.
Thoroughly vacuum lint from sensor bar mounting insulator. Check resistance between sensor strips and chassis (must be infinite >20 MΩ when dry). Turn cycle knob to 0, hold Start/Pause and Anti-Crease buttons for 6 seconds until buzzer beeps three times, then switch to Off.



