Hoover F1 — Dryer
[ACTIVE]Hoover H-DRY 300 / 500 Heat-Pump & Auto Care Tumble Dryer: Air intake temperature sensor fault F1; front air temperature probe disconnected or reading outside allowable bounds.
On Hoover dryers utilizing H-DRY Auto Care thermodynamic heat-pump circuit, active conductivity sensor bars, and Eco-Power compressor control: Defective front NTC thermistor, loose pin terminal on air duct harness, or internal short circuit.
Disconnect wire harness at front sensor. Measure resistance (~10 kΩ–20 kΩ at 25°C). Replace sensor assembly if open or short. Turn cycle knob to 0, hold Start/Pause and Anti-Crease buttons for 6 seconds until buzzer beeps three times, then switch to Off.



