Hoover F3 — Dryer
[ACTIVE]Hoover H-DRY 300 / 500 Heat-Pump & Auto Care Tumble Dryer: Compressor discharge pipe high-temperature limit exceeded F3; temperature on discharge line exceeds 115°C.
On Hoover dryers utilizing H-DRY Auto Care thermodynamic heat-pump circuit, active conductivity sensor bars, and Eco-Power compressor control: Low refrigerant charge causing superheat, blocked heat exchanger coil, or defective discharge NTC sensor.
Allow system to cool. Thoroughly clean heat exchanger and filters. Measure discharge sensor (~10 kΩ at 25°C). Inspect sealed system for oil trace (leak). Turn cycle knob to 0, hold Start/Pause and Anti-Crease buttons for 6 seconds until buzzer beeps three times, then switch to Off.



