Hoover F4 — Dryer
[ACTIVE]Hoover H-DRY 300 / 500 Heat-Pump & Auto Care Tumble Dryer: Condensate evacuation pump failure F4; water level switch in collection sump remains active after pump run cycle.
On Hoover dryers utilizing H-DRY Auto Care thermodynamic heat-pump circuit, active conductivity sensor bars, and Eco-Power compressor control: Lint sludge blocking pump intake, kinked condensate drain tube, or open pump motor coil (~120–280 Ω).
Clean lower sump chamber and float switch. Inspect small drain tube to upper tank for clogs. Measure pump resistance (~120–280 Ω). Turn cycle knob to 0, hold Start/Pause and Anti-Crease buttons for 6 seconds until buzzer beeps three times, then switch to Off.



