Hotpoint C81

Hotpoint error code C81 indicates: Hotpoint Active Induction & CleanProtect Cooktop: Touch control panel thermal warning C81; temperature sensor beneath front glass panel senses heat exceeding 75°C..

The primary root cause for Hotpoint code C81 is: On Hotpoint cooktops: Hot pan shifted or placed onto front touch sensor glass area, or heat radiating from large griddle pan overlapping controls..

To resolve error code C81: Immediately move hot cookware away from front glass control area. Leave hob off for 5–10 minutes until sensor cools below 60°C. Disconnect mains power for 90 seconds, ensure no cookware rests on sensors, then re-apply power.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Hotpoint code C81 persists, the physical component causing On Hotpoint cooktops: Hot pan shifted or placed onto front touch sensor glass area, or heat radiating from large griddle pan overlapping controls. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.