Hotpoint SUD

Hotpoint error code SUD indicates: Hotpoint ActiveCare & GentlePower Ultima Washing Machine: Excessive suds detection SUD; electronic pressure transducer senses thick foam blanket stalling drain pump motor..

The primary root cause for Hotpoint code SUD is: On Hotpoint washing machines: Massive overdose of concentrated laundry detergent, incorrect high-foaming hand-wash soap, or restricted siphon pipe..

To resolve error code SUD: Pause cycle and allow foam to dissipate for 20 minutes. Run cold rinse cycle without soap. Inspect drain filter coin trap for lint obstructions. Turn cycle knob to 12 o'clock, hold Cancel/Reset for 3 seconds, and power cycle mains switch for 60 seconds.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Hotpoint code SUD persists, the physical component causing On Hotpoint washing machines: Massive overdose of concentrated laundry detergent, incorrect high-foaming hand-wash soap, or restricted siphon pipe. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.