Indesit F11 — Dishwasher
[ACTIVE]Indesit Push&Go & Extra Hygiene DFP Series Dishwasher: BLDC circulation pump inverter drive fault F11; IPM module detects overcurrent, loss of synchronism, or phase disconnect.
On Indesit dishwashers: Short-circuit between motor stator windings, seized ceramic rotor bearings, or damaged 3-phase IPM inverter silicon.
Measure resistance across each phase pair U-V, V-W, U-W on circulation motor (symmetrical ~45–60 Ω). Check for free shaft spin. Replace circulation pump or IPM board. Press and hold Start/Reset for 5 seconds until drain pump runs, wait 60 seconds, then power cycle ON/OFF.



