Indesit F3 — Dishwasher
[ACTIVE]Indesit Push&Go & Extra Hygiene DFP Series Dishwasher: Wash heating system failure F3; wash water does not achieve target temperature within 25 minutes of heating phase.
On Indesit dishwashers: Open-circuit tubular flow-through heating element, burnt PCB heater relay contacts, or tripped thermal safety limit cutouts.
Measure flow-through heater resistance (nominal 24–29 Ω, ~2040W). Check thermal cutouts on heater housing (0 Ω continuity). Verify 230V AC output from PCB relay. Press and hold Start/Reset for 5 seconds until drain pump runs, wait 60 seconds, then power cycle ON/OFF.



