Indesit F8 — Dishwasher
[ACTIVE]Indesit Push&Go & Extra Hygiene DFP Series Dishwasher: Sump water level inconsistency or diverter fault F8; OWI sensor optical reading conflicts with pressure calculation.
On Indesit dishwashers: Fat or grease film coating the optical sensor lens, heavy detergent foaming, or motorized diverter valve (MDV) stuck mid-position.
Clean optical OWI sensor face in sump bottom with warm soapy water and soft sponge. Verify diverter motor resistance (6.0–7.5 kΩ). Recalibrate optical sensor. Press and hold Start/Reset for 5 seconds until drain pump runs, wait 60 seconds, then power cycle ON/OFF.



