Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Korting F18
FAQ TREEWhat does error code F18 mean on a Korting appliance?
Korting error code F18 indicates: Körting KBO / KBE OptiBake Built-in Multifunction & Steam Convection Oven: Diagnostic fault code F18 registered by the microcomputer controller. Oven child safety electronic lock key sensor permanently activated or stuck closed (>30s).
What is the root cause of Korting error code F18?
The primary root cause for Korting code F18 is: On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with Gorenje OptiBake electronic chassis, PT1000 sensor (1080 Ω at 20°C), 2200W convection circular element (24-27 Ω), 1200W top grill, and tangential cooling blower (180-240 Ω): conductive grease film over touch glass panel, capacitive spring misaligned, or touch IC channel shorted. Metrological tolerance verification: capacitive spring contact resistance to glass pad <0.5 Ω; sensor power supply 5.0V ± 0.2V DC..
How do I fix or resolve Korting error code F18?
To resolve error code F18: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: thoroughly clean glass surface with degreasing agent, inspect spring contacts and check 5V DC supply rail. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn oven selector knob to 0 position. Press and hold Temp and Clock buttons together for 5 seconds until control board beeps, clearing fault record.
Is it safe to clear Korting error code F18 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Korting code F18 persists, the physical component causing On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with Gorenje OptiBake electronic chassis, PT1000 sensor (1080 Ω at 20°C), 2200W convection circular element (24-27 Ω), 1200W top grill, and tangential cooling blower (180-240 Ω): conductive grease film over touch glass panel, capacitive spring misaligned, or touch IC channel shorted. Metrological tolerance verification: capacitive spring contact resistance to glass pad <0.5 Ω; sensor power supply 5.0V ± 0.2V DC. must be inspected or replaced.
How do I test electrical resistance for Korting code F18 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Korting code F18?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



