Liebherr E3 — Oven
[ACTIVE]Liebherr Gourmet Built-in Convection Oven: Diagnostic fault code E3 registered by the microcomputer controller. Oven temperature sensor failure.. Liebherr Gourmet Built-in Convection Oven: Diagnostic fault code E3 reported by internal controller.
On Liebherr appliances engineered with Liebherr Gourmet precise electronic thermoregulation and tangential cross-flow cooling: The oven's main temperature probe (NTC sensor) is open or shorted. Metrological tolerance verification: .
Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: Disconnect power. Access the sensor inside the oven cavity, disconnect it, and measure its resistance. It should be around 1080 Ohms at room temperature. Replace if faulty.. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn selector to Off, isolate main breaker for 60 seconds, restore power, hold Clock and Temperature buttons for 5 seconds.



