Liebherr F8 — Dishwasher
[ACTIVE]Liebherr Premium AquaStop Integrated Dishwasher: Diagnostic fault code F8 registered by the microcomputer controller. Dishwasher diverter valve error.. Liebherr Premium AquaStop Integrated Dishwasher: Diagnostic fault code F8 reported by internal controller.
On Liebherr appliances engineered with Liebherr electronic wash management, flow-through heater, and AquaSafe leak protection: The valve that directs water to the upper or lower spray arms is stuck or faulty. Metrological tolerance verification: door lock mechanism motor coil 2.2 kΩ to 2.8 kΩ; microswitch 0.0 Ω closed.
Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure door lock motor coil resistance (~2.5 kΩ) and verify microswitch continuity (0.0 Ω). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn off unit. Hold Start/Pause while turning on power switch, release after 4 seconds, then press Start/Pause 3 times to enter service reset mode.



