Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Nardi ER27
FAQ TREEWhat does error code ER27 mean on a Nardi appliance?
Nardi error code ER27 indicates: Nardi FEX / FEA / FRA Built-in Electric Multifunction & Pyrolytic Italian Oven: Operational diagnostic fault code Er27 signaled by internal electronics. Steam boiler temperature sensor NTC open or short circuit (<800 Ω or >250 kΩ).
What is the root cause of Nardi error code ER27?
The primary root cause for Nardi code ER27 is: On Nardi kitchen suites engineered with PT500 temperature sensor (540 Ω at 20°C), shaded-pole tangential cooling motor, 2200W circular turbo heater, motorized latch, and electronic relay board: Boiler thermistor wire fractured by thermal cycling or moisture ingress into sensor capsule Multimeter diagnostic parameter: nominal NTC resistance 10.0 kΩ at 25°C, dropping smoothly to 1.2 kΩ at 90°C and ~850 Ω at 100°C..
How do I fix or resolve Nardi error code ER27?
To resolve error code ER27: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: unplug NTC connector from board and measure resistance while checking response to gentle warm air. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Turn mode dial to 0. Press and hold Clock and Stop buttons for 5 seconds until buzzer beeps twice, resetting internal microprocessor error log.
Is it safe to clear Nardi error code ER27 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Nardi code ER27 persists, the physical component causing On Nardi kitchen suites engineered with PT500 temperature sensor (540 Ω at 20°C), shaded-pole tangential cooling motor, 2200W circular turbo heater, motorized latch, and electronic relay board: Boiler thermistor wire fractured by thermal cycling or moisture ingress into sensor capsule Multimeter diagnostic parameter: nominal NTC resistance 10.0 kΩ at 25°C, dropping smoothly to 1.2 kΩ at 90°C and ~850 Ω at 100°C. must be inspected or replaced.
How do I test electrical resistance for Nardi code ER27 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Nardi code ER27?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?