Ocean F11 — Dishwasher
[ACTIVE]Ocean Oceanica / AquaStop Electronic Built-in & Freestanding Dishwasher: Diagnostic fault code F11 registered by the microcomputer controller. Door latch safety microswitch open during active cycle, wash program paused unexpectedly
System architecture (Ocean wash module, synchronous circulation pump, 1800W flow-through heater, and float safety microswitch): door catch strike plate misadjusted, worn microswitch contacts, or broken door hinge spring. Metrological test specification: door safety microswitch contact resistance < 0.2 Ω when door firmly closed; open circuit when latched open.
Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: inspect door latch alignment; measure microswitch continuity while operating door handle latch manually. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: press and hold the Program / Reset button for 5 seconds until the status indicator turns off and the drain pump runs for 30 seconds to evacuate residual water.



