Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Samet H13
FAQ TREEWhat does error code H13 mean on a Samet appliance?
Samet error code H13 indicates: Samet Enamelled Vitroceramic & Induction Cooktop with Safety Gas Burners: Operational diagnostic fault code H13 signaled by internal electronics. Left induction inverter module IGBT driver pulse fault or desaturation overcurrent trip.
What is the root cause of Samet error code H13?
The primary root cause for Samet code H13 is: On Samet kitchen suites engineered with resonant induction generator inverter stage, 100 kΩ coil thermistor, 10 kΩ heatsink NTC, 12V DC fan with tachometer, and fast gas safety thermocouples: Punctured IGBT gate insulation, shorted collector-emitter junction, or blown gate drive resistor Multimeter diagnostic parameter: IGBT collector-emitter diode test drop 0.4V to 0.7V forward, infinite reverse; gate-to-emitter >1 MΩ..
How do I fix or resolve Samet error code H13?
To resolve error code H13: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: test left inverter IGBTs with digital multimeter in diode test mode; check gate drive series resistor (10-47 Ω). Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Switch off electrical isolator switch for 60 seconds. Restore power, touch Key Lock key for 7 seconds continuously until lock icon turns off.
Is it safe to clear Samet error code H13 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Samet code H13 persists, the physical component causing On Samet kitchen suites engineered with resonant induction generator inverter stage, 100 kΩ coil thermistor, 10 kΩ heatsink NTC, 12V DC fan with tachometer, and fast gas safety thermocouples: Punctured IGBT gate insulation, shorted collector-emitter junction, or blown gate drive resistor Multimeter diagnostic parameter: IGBT collector-emitter diode test drop 0.4V to 0.7V forward, infinite reverse; gate-to-emitter >1 MΩ. must be inspected or replaced.
How do I test electrical resistance for Samet code H13 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Samet code H13?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?