Samet rF01

Samet error code RF01 indicates: Samet Vintage & Built-in Dual-Zone Total NoFrost Refrigerator-Freezer: Operational diagnostic fault code rF01 signaled by internal electronics. Refrigerator fresh food compartment air temperature sensor NTC open circuit (>100 kΩ at 25°C).

The primary root cause for Samet code RF01 is: On Samet kitchen suites engineered with sheath defrost heating element (240-330 Ω), 72°C thermal cut-out fuse, 10 kΩ evaporator NTC, brushless DC circulation fan, and PTC compressor starter: Thermistor lead wire severed behind liner molding, cracked sensor capsule, or unplugged PCB terminal Multimeter diagnostic parameter: nominal NTC thermistor resistance 10 kΩ ±5% at 25°C (rises to ~28 kΩ at 4°C); infinite reading indicates open..

To resolve error code RF01: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: access sensor harness at main electronic control box and measure resistance across fresh food NTC pins. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Press and hold Refrigerator Cool and Alarm Reset buttons simultaneously for 5 seconds until audible confirmation tone sounds, wiping error state.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Samet code RF01 persists, the physical component causing On Samet kitchen suites engineered with sheath defrost heating element (240-330 Ω), 72°C thermal cut-out fuse, 10 kΩ evaporator NTC, brushless DC circulation fan, and PTC compressor starter: Thermistor lead wire severed behind liner molding, cracked sensor capsule, or unplugged PCB terminal Multimeter diagnostic parameter: nominal NTC thermistor resistance 10 kΩ ±5% at 25°C (rises to ~28 kΩ at 4°C); infinite reading indicates open. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.