Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Scholtès F13
FAQ TREEWhat does error code F13 mean on a Scholtès appliance?
Scholtès error code F13 indicates: Scholtès Galileo / Multi-Oven / S-Line Pyrolytic Built-in Oven: Diagnostic fault code F13 registered by the microcomputer controller. Steam generator injection boiler NTC probe fault.
What is the root cause of Scholtès error code F13?
The primary root cause for Scholtès code F13 is: On Scholtès appliances engineered with Galileo electronic architecture with high-density pyrolytic thermal barrier, PT500 probe feedback, Hall-effect cooling fan regulation, and bi-metallic motorized door latch: steam generator thermistor open Metrological tolerance verification: nominal 10.0 kΩ at 25°C, 1.2 kΩ at 90°C...
How do I fix or resolve Scholtès error code F13?
To resolve error code F13: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure boiler NTC sensor resistance across terminals. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn temperature and function dials to 0. Switch off oven circuit breaker for 60 seconds. Restore power, touch and hold the Timer/Clock button for 4 seconds until '0:00' flashes and error code extinguishes.
Is it safe to clear Scholtès error code F13 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Scholtès code F13 persists, the physical component causing On Scholtès appliances engineered with Galileo electronic architecture with high-density pyrolytic thermal barrier, PT500 probe feedback, Hall-effect cooling fan regulation, and bi-metallic motorized door latch: steam generator thermistor open Metrological tolerance verification: nominal 10.0 kΩ at 25°C, 1.2 kΩ at 90°C.. must be inspected or replaced.
How do I test electrical resistance for Scholtès code F13 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Scholtès code F13?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?