Severin Er1

Severin error code ER1 indicates: Severin Sevo Smart Control / Senoa Digital Electric Barbecue & Table Grill: Diagnostic fault code Er1 registered by the microcomputer controller. Removable core meat probe NTC sensor open circuit or disconnected.

The primary root cause for Severin code ER1 is: On Severin appliances engineered with BoostZone dual-heating stainless coil (3000W, 500°C), core meat temperature probe NTC (10 kΩ at 25°C), OLED rotary control unit, and water reflector tray safety switch: probe cable pinched by lid or mini-jack socket pin oxidized Metrological tolerance verification: core probe NTC resistance 100 kΩ at 25°C (~3.3 kΩ at 100°C); jack contact < 0.2 Ω..

To resolve error code ER1: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: inspect 3.5mm jack terminal; measure probe resistance; replace plug-in meat probe. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: turn off the rotary dial, disconnect the power plug, ensure the water tray is filled above the Min mark, reconnect and press the OLED dial knob down for 5 seconds.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Severin code ER1 persists, the physical component causing On Severin appliances engineered with BoostZone dual-heating stainless coil (3000W, 500°C), core meat temperature probe NTC (10 kΩ at 25°C), OLED rotary control unit, and water reflector tray safety switch: probe cable pinched by lid or mini-jack socket pin oxidized Metrological tolerance verification: core probe NTC resistance 100 kΩ at 25°C (~3.3 kΩ at 100°C); jack contact < 0.2 Ω. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.