Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Siemens E106
FAQ TREEWhat does error code E106 mean on a Siemens appliance?
Siemens error code E106 indicates: Siemens iQ500 / iQ700 studioLine activeClean & pulseSteam TFT Touchdisplay Plus: Tangential cooling fan Hall sensor feedback missing E106; cooling blower fails to turn or tachometer feedback absent..
What is the root cause of Siemens error code E106?
The primary root cause for Siemens code E106 is: On Siemens ovens: Jammed tangential cross-flow blower wheel, open motor winding (~120–160 Ω), or defective Hall sensor board on fan motor..
How do I fix or resolve Siemens error code E106?
To resolve error code E106: Disconnect mains. Remove top panel. Ensure cross-flow fan spins smoothly. Measure motor winding resistance (~120–160 Ω). Check 5V DC supply to Hall sensor. Touch On/Off sensor, isolate circuit breaker for 60 seconds, re-engage and touch Key lock symbol for 3 seconds.
Is it safe to clear Siemens error code E106 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Siemens code E106 persists, the physical component causing On Siemens ovens: Jammed tangential cross-flow blower wheel, open motor winding (~120–160 Ω), or defective Hall sensor board on fan motor. must be inspected or replaced.
How do I test electrical resistance for Siemens code E106 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test 3-Phase Motor Windings / Tacho Generator / Carbon Brushes across Across phase pins U-V, V-W, U-W on motor harness; across tacho pins. Expected nominal reading is 3Ω–6Ω (BLDC phase U-V-W) / 60Ω–180Ω (Tacho coil) / 1.5Ω–3.5Ω (Universal stator). Tolerance: BLDC phase winding values must be strictly balanced within ±0.3Ω. Hand rotation generates 1V–4V AC on tacho..
What safety protocol must be followed before servicing Siemens code E106?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



