Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Siemens F37
FAQ TREEWhat does error code F37 mean on a Siemens appliance?
Siemens error code F37 indicates: Siemens iQ500 / iQ700 / iQ800 studioLine iQdrive & i-Dos intelligent dosing: NTC sensor resistance open or high deviation F37; temperature value reads unrealistic cold (<-10°C) during wash..
What is the root cause of Siemens error code F37?
The primary root cause for Siemens code F37 is: On Siemens washers: Internal fracture in NTC ceramic bead, broken wire in lower wiring loom under tub vibrations, or loose sensor connector plug..
How do I fix or resolve Siemens error code F37?
To resolve error code F37: Measure NTC resistance directly at heater terminals (nominal ~10 kΩ at 20°C, ~4.9 kΩ at 40°C). Check wire continuity up to main PCB connector. Set selector to position 8 (spin), hold Finish In capacitive key, advance selector to position 9, wait for P1 display, return to 0.
Is it safe to clear Siemens error code F37 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Siemens code F37 persists, the physical component causing On Siemens washers: Internal fracture in NTC ceramic bead, broken wire in lower wiring loom under tub vibrations, or loose sensor connector plug. must be inspected or replaced.
How do I test electrical resistance for Siemens code F37 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Siemens code F37?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



