Siltal AL02

Siltal error code AL02 indicates: Siltal Frigoriferi Abbiategrasso Static & Ventilated Cold Refrigerator: Diagnostic fault code AL02 registered by the microcomputer controller. Condenser coil discharge line overheating; temperature sensor exceeded 70°C safety trip.

The primary root cause for Siltal code AL02 is: On Siltal appliances engineered with Siltal Abbiategrasso refrigeration circuit, Danfoss/Aspera compressor with R134a/R600a, NTC thermistors, and aluminum tube defrost heater: heavy dust and pet hair blocking static condenser back grid or condenser fan motor stopped Metrological tolerance verification: condenser safety cut-off limit 70°C; maximum normal operating temperature 55°C..

To resolve error code AL02: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: vacuum dust from rear condenser grid, verify 50 mm rear wall clearance, and test condenser fan. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn the thermostat temperature dial fully counter-clockwise to position '0' (Off). Unplug the power cable from the wall outlet for 5 minutes. Reconnect power and set the dial to intermediate position '3', holding the Quick Chill button for 3 seconds to clear alarm tone.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Siltal code AL02 persists, the physical component causing On Siltal appliances engineered with Siltal Abbiategrasso refrigeration circuit, Danfoss/Aspera compressor with R134a/R600a, NTC thermistors, and aluminum tube defrost heater: heavy dust and pet hair blocking static condenser back grid or condenser fan motor stopped Metrological tolerance verification: condenser safety cut-off limit 70°C; maximum normal operating temperature 55°C. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.