Vestel SA

Vestel error code SA indicates: Vestel Eco Dual / FrostFree Total NoFrost Multi-Flow Refrigerator: Diagnostic fault code SA registered by the microcomputer controller. Serial UART communication loss between main control PCB and compressor inverter board.

The primary root cause for Vestel code SA is: On Vestel European OEM white goods platforms manufactured in Manisa engineered with Total NoFrost cooling circuit, 240W defrost element (220-300 Ω), 10 kΩ NTC compartment sensors, 72°C thermal cut-out fuse, and 12V DC evaporator fan (2.5W): inverter communication wire severed, optocoupler receiver blown or inverter board DC rail unpowered. Metrological tolerance verification: inverter board AC input 230V AC; UART PWM communication signal 0 to 5.0V DC pulse train..

To resolve error code SA: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: verify 230V AC mains supply to inverter board and measure PWM logic signal with multimeter in Hz mode. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Open fresh food compartment door. Press and hold Refrigerator Quick Cool and Freezer Temp Set buttons simultaneously for 5 seconds until the control panel beeps and displays '00'.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Vestel code SA persists, the physical component causing On Vestel European OEM white goods platforms manufactured in Manisa engineered with Total NoFrost cooling circuit, 240W defrost element (220-300 Ω), 10 kΩ NTC compartment sensors, 72°C thermal cut-out fuse, and 12V DC evaporator fan (2.5W): inverter communication wire severed, optocoupler receiver blown or inverter board DC rail unpowered. Metrological tolerance verification: inverter board AC input 230V AC; UART PWM communication signal 0 to 5.0V DC pulse train. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.