Zerowatt F1 — Dryer
[ACTIVE]Zerowatt ZTD Condenser & Heat-Pump Tumble Dryer: Air intake temperature sensor fault F1; front air temperature probe disconnected or reading outside allowable bounds.
On Zerowatt dryers utilizing ZTD condensation airflow duct system, bi-metal safety thermal cut-out, and electromechanical program timer: Defective front NTC thermistor, loose pin terminal on air duct harness, or internal short circuit.
Disconnect wire harness at front sensor. Measure resistance (~10 kΩ–20 kΩ at 25°C). Replace sensor assembly if open or short. Rotate dial to Off, press Start and Low Heat buttons for 5 seconds until the buzzer chirps twice, then release and turn to Off.



