Arthur Martin E04

Arthur Martin error code E04 indicates: Arthur Martin ARA / ARB Series / Silentic Froid Refrigerator: High temperature alarm in freezer compartment E04; freezer temperature rises above -9°C for sustained duration..

The primary root cause for Arthur Martin code E04 is: On Arthur Martin (Arthur Martin ARA / ARB Series / Silentic Froid Refrigerator) models: Refrigerant leak (loss of R600a charge), inefficient compressor valves, door left ajar, or severe frost buildup restricting airflow through evaporator..

To resolve error code E04: Check magnetic door seal alignment. Inspect evaporator frost pattern (even frost coating indicates healthy charge; bare pipe indicates leak). Hold Départ/Pause and Option buttons firmly for 5 seconds until the red indicator extinguishes and service memory resets.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Arthur Martin code E04 persists, the physical component causing On Arthur Martin (Arthur Martin ARA / ARB Series / Silentic Froid Refrigerator) models: Refrigerant leak (loss of R600a charge), inefficient compressor valves, door left ajar, or severe frost buildup restricting airflow through evaporator. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.