Arthur Martin E33

Arthur Martin error code E33 indicates: Arthur Martin Electrolux AWF Series / Silence Plus Washer: Level incongruence alarm E33; discrepancy between electronic pressure sensor and anti-boil protection switch..

The primary root cause for Arthur Martin code E33 is: On Arthur Martin (Arthur Martin Electrolux AWF Series / Silence Plus Washer) models: Current leakage from heating element to ground (> 2 mA), defective anti-boil mechanical switch, or faulty resistor network on PCB level sensing circuit..

To resolve error code E33: Measure heating element insulation resistance to earth with 500V megohmmeter (must exceed 10 MΩ; if < 2 MΩ replace heating element!). Inspect anti-boil switch continuity. Hold Départ/Pause and Option buttons firmly for 5 seconds until the red indicator extinguishes and service memory resets.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Arthur Martin code E33 persists, the physical component causing On Arthur Martin (Arthur Martin Electrolux AWF Series / Silence Plus Washer) models: Current leakage from heating element to ground (> 2 mA), defective anti-boil mechanical switch, or faulty resistor network on PCB level sensing circuit. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.