Asko E10

Asko error code E10 indicates: Asko Quattro Construction / Steel Seal / Logic Scandinavian Washer: Water level sensing error E10; analog pressure sensor output frequency outside calibrated operational bounds (21–27 kHz)..

The primary root cause for Asko code E10 is: On Asko washing machines utilizing Quattro Construction 4-shock suspension, Steel Seal rubber-free door hygienic ring, and Pro Wash water circulation: Soap scum clogging pressure bell chamber, pinholed pressure transducer hose, or internal LC oscillator fault..

To resolve error code E10: Disconnect and flush pressure bell with warm water. Inspect silicone hose for punctures. Measure sensor supply voltage (5V DC) and signal pin. Press and hold the Stop button for 4 seconds until the program resets. Power off with master button, wait 15 seconds, and power back on.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Asko code E10 persists, the physical component causing On Asko washing machines utilizing Quattro Construction 4-shock suspension, Steel Seal rubber-free door hygienic ring, and Pro Wash water circulation: Soap scum clogging pressure bell chamber, pinholed pressure transducer hose, or internal LC oscillator fault. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.