Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Atlantic ER 02
FAQ TREEWhat does error code ER 02 mean on a Atlantic appliance?
Atlantic error code ER 02 indicates: Atlantic Alféa Excellia / Extensa A.I. / Alféa Hybrid Duo Inverter Heat Pump: Diagnostic fault code Er 02 registered by the microcomputer controller. Compressor discharge pipe temperature high limit cut-out.
What is the root cause of Atlantic error code ER 02?
The primary root cause for Atlantic code ER 02 is: On Atlantic appliances engineered with co-developed Fujitsu twin-rotary DC inverter outdoor stage, Siemens Navistem / RVS hydraulic regulator, electronic expansion valve with 46 Ω stepper phases, and 10 kΩ NTC flow/return temperature sensors: compressor discharge pipe overheating (> 115°C) due to severe refrigerant leak, failed EEV, or broken suction accumulator Metrological tolerance verification: discharge pipe NTC thermistor 50 kΩ at 25°C, 3.8 kΩ at 100°C; safety cutoff at 115°C..
How do I fix or resolve Atlantic error code ER 02?
To resolve error code ER 02: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure discharge thermistor resistance and connect digital manifold gauges to verify suction superheat. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: On the Navistem user controller: press OK and hold the 'i' button for 3 seconds to access Specialist mode. Go to line 6700-6800 (Diagnostics), select 'Reset fault log' and set to 'Yes', then press OK. For hard lockout, switch off the 230V/400V mains breaker for 60 seconds to discharge the DC link.
Is it safe to clear Atlantic error code ER 02 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Atlantic code ER 02 persists, the physical component causing On Atlantic appliances engineered with co-developed Fujitsu twin-rotary DC inverter outdoor stage, Siemens Navistem / RVS hydraulic regulator, electronic expansion valve with 46 Ω stepper phases, and 10 kΩ NTC flow/return temperature sensors: compressor discharge pipe overheating (> 115°C) due to severe refrigerant leak, failed EEV, or broken suction accumulator Metrological tolerance verification: discharge pipe NTC thermistor 50 kΩ at 25°C, 3.8 kΩ at 100°C; safety cutoff at 115°C. must be inspected or replaced.
How do I test electrical resistance for Atlantic code ER 02 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Atlantic code ER 02?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?