Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bauknecht F27
FAQ TREEWhat does error code F27 mean on a Bauknecht appliance?
Bauknecht error code F27 indicates: Bauknecht SuperEco & GentlePower Zen Motor Direct Drive Washing Machine: Drum reversing motor relay contact stuck F27; motor can rotate in only one direction due to welded relay contacts..
What is the root cause of Bauknecht error code F27?
The primary root cause for Bauknecht code F27 is: On Bauknecht washing appliances: High inductive arc discharge during drum reversal under heavy laundry load welding reversing relay contacts on PCB..
How do I fix or resolve Bauknecht error code F27?
To resolve error code F27: De-energize machine. Tap relay casing lightly or measure contact continuity with power off (normally open contacts must read infinite ohms). Replace PCB relay. Turn selector to Drain/Spin, press Start/Pause button 4 times within 5 seconds to clear fault, or hold Reset for 3s.
Is it safe to clear Bauknecht error code F27 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bauknecht code F27 persists, the physical component causing On Bauknecht washing appliances: High inductive arc discharge during drum reversal under heavy laundry load welding reversing relay contacts on PCB. must be inspected or replaced.
How do I test electrical resistance for Bauknecht code F27 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Bauknecht code F27?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



